Thanks everyone for the info. My other radio a Mark V has a Roofing filter
installed by NP4A and I do not have it here. The roofing filter that I have
here to install to the MP does not have the jumper cable. Where did I can
find that cable? Thanks & 73'
Alfredo Vélez WP3C
e-mail: mailto:wp3c@aol.com
Web: http://www.wp3c.qth.com
WP3C DX Cluster Node: telnet://wp3c.hopto.org
-----Original Message-----
From: K1TTT [mailto:K1TTT@ARRL.NET]
Sent: Sunday, March 15, 2009 3:26 PM
To: 'Alfredo Velez WP3C'; yaesu@contesting.com
Subject: RE: [Yaesu] Problems with Roofing Filter
Incorrect procedure... unplug the cable from j2003 and plug that into j1 on
the filter board, then use the supplied jumper to go from j2 on the board
back to j2003.
David Robbins K1TTT
e-mail: mailto:k1ttt@arrl.net
web: http://www.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
> -----Original Message-----
> From: Alfredo Velez WP3C [mailto:wp3c@aol.com]
> Sent: Sunday, March 15, 2009 17:49
> To: yaesu@contesting.com
> Subject: [Yaesu] Problems with Roofing Filter
>
> Hi
>
> I am installing the INRAD Roofing Filter to a Yaesu FT-1000MP and it
> is
> not working, the steps that I am following are:
>
> 1- I put the Roofing Filter in the AF-FIL Unit
>
> 2- Put the J2003 (Yellow) in the J1 of the Filter
>
> 3- Put the J2005 (Orange) in the J2 of the filter
>
> After this I do not receive anything, Can someone help me with this?
> Thanks
> and 73?
>
>
>
> Alfredo Vélez WP3C
> e-mail: <mailto:wp3c@aol.com> mailto:wp3c@aol.com
> Web: <http://www.wp3c.qth.com/> http://www.wp3c.qth.com
> WP3C DX Cluster Node: <telnet://wp3c.hopto.org/> telnet://wp3c.hopto.org
>
>
> _______________________________________________
> Yaesu mailing list
> Yaesu@contesting.com
> http://lists.contesting.com/mailman/listinfo/yaesu
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|