Incorrect procedure... unplug the cable from j2003 and plug that into j1 on
the filter board, then use the supplied jumper to go from j2 on the board
back to j2003.
David Robbins K1TTT
e-mail: mailto:k1ttt@arrl.net
web: http://www.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
> -----Original Message-----
> From: Alfredo Velez WP3C [mailto:wp3c@aol.com]
> Sent: Sunday, March 15, 2009 17:49
> To: yaesu@contesting.com
> Subject: [Yaesu] Problems with Roofing Filter
>
> Hi
>
> I am installing the INRAD Roofing Filter to a Yaesu FT-1000MP and it
> is
> not working, the steps that I am following are:
>
> 1- I put the Roofing Filter in the AF-FIL Unit
>
> 2- Put the J2003 (Yellow) in the J1 of the Filter
>
> 3- Put the J2005 (Orange) in the J2 of the filter
>
> After this I do not receive anything, Can someone help me with this?
> Thanks
> and 73?
>
>
>
> Alfredo Vélez WP3C
> e-mail: <mailto:wp3c@aol.com> mailto:wp3c@aol.com
> Web: <http://www.wp3c.qth.com/> http://www.wp3c.qth.com
> WP3C DX Cluster Node: <telnet://wp3c.hopto.org/> telnet://wp3c.hopto.org
>
>
> _______________________________________________
> Yaesu mailing list
> Yaesu@contesting.com
> http://lists.contesting.com/mailman/listinfo/yaesu
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|