Happy Thanksgiving to all.
Got this from TT a few years ago:
Key the Titanic with your *external* keyer and use the Titanic key-out to
key the '1000. It's helpful to have a true weight control on your keyer or
the on-air c-w will be light. Relay latency adds up. Connect the '1000 amp
relay as usual to the Titanic amp relay, and QSK works on c-w and PTT/VOX
works on SSB.
73 Dave N3HE
----- Original Message -----
From: "William Liporace - WC2L" <wc2l@wc2l.com>
To: <yaesu@contesting.com>
Sent: Monday, November 19, 2007 7:11 PM
Subject: [Yaesu] FT-1000 keying a Ten-Tec Titan
> Good Evening,
> I am currently running a Yaesu FT-1000 with a Ten-Tec Titan. I am
> currently keying the amp with the band data jack on the FT-1000. This uses
> Pin 2 (TNX GND), Pin 3 (GND), and Pin 8 (Linear). Pin 2 goes to Key in and
> Pin 8 goes to Key out on the Titan with the ground being common on both
> RCA jacks.
>
> With this configuration, the Titan MUST be powered on and set for QSK mode
> in order for the FT-1000 to TX RF. I like the quiet and quick keying of
> the FT-1000. I know I can turn on the internal relay of the Ft-1000, set
> the Titan for PTT and key the amplifier.
>
> I am using the band data for antenna switching. This is a great feature. I
> want to keep this flexibility.
>
> I have read:
> http://kb.tentec.com/index.php?article=39
> http://n1eu.com/Yaesu/MPAcom.htm (as a reference)
>
>
> How do I allow the radio to TX RF with out the AMP on?
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|