Good Evening,
I am currently running a Yaesu FT-1000 with a Ten-Tec Titan. I am currently
keying the amp with the band data jack on the FT-1000. This uses Pin 2 (TNX
GND), Pin 3 (GND), and Pin 8 (Linear). Pin 2 goes to Key in and Pin 8 goes to
Key out on the Titan with the ground being common on both RCA jacks.
With this configuration, the Titan MUST be powered on and set for QSK mode in
order for the FT-1000 to TX RF. I like the quiet and quick keying of the
FT-1000. I know I can turn on the internal relay of the Ft-1000, set the Titan
for PTT and key the amplifier.
I am using the band data for antenna switching. This is a great feature. I want
to keep this flexibility.
I have read:
http://kb.tentec.com/index.php?article=39
http://n1eu.com/Yaesu/MPAcom.htm (as a reference)
How do I allow the radio to TX RF with out the AMP on?
TNX es 73 Will
telnet://dxc.wc2l.com
http://www.wc2l.com (needs to be updated)
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|