It is my understanding that the Pro III implemented a fixed 15Khz roofing
filter like that used in the 7800 but the earlier Pro II (which I had) did
not. All the reading I have done on the subject indicates the 15Khz to be
too wide to provide the full benefit so now we are seeing rigs with two and
three selectable and narrower roofing filter bandwidths. I believe the new
FT-2000 is coming that way from the start.
The Sherwood Engineering page has good explanations of the whole roofing
filter issue as does the Inrad page.
Also a correction to my earlier post....about close spaced test results was
suppose to say Dynamic Range not IMD....My confusion on that one...
Cecil...
----- Original Message -----
From: "Adam Farson" <farson@shaw.ca>
To: "Yaesu Contesting Reflector" <yaesu@contesting.com>
Sent: Friday, July 21, 2006 1:14 AM
Subject: [Yaesu] FW: roofing filters
> Hi Cecil,
>
> Er...the IC-756Pro series does have 15 kHz roofing filters at the first
> (64.455 MHz) and second (455 kHz) IF's.
>
> Cheers for now, 73,
> Adam VA7OJ/AB4OJ
>
>
>
> Scanned for viruses by Blue Coat
> http://www.WinProxy.com/
> _______________________________________________
> Yaesu mailing list
> Yaesu@contesting.com
> http://lists.contesting.com/mailman/listinfo/yaesu
>
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|