I believe it's plug in because it is an option filter in the FT-1000 not a
D....
Cecil....
----- Original Message -----
From: <marcelo@alternex.com.br>
To: <yaesu@contesting.com>
Cc: "Karty, Steven L CIV NCS NC2" <steven.karty@dhs.gov>
Sent: Monday, June 26, 2006 9:27 AM
Subject: Re: [Yaesu] FT1000D Filter Location (UNCLASSIFIED)
>
> Hello,
>
> Thanks for the help.
>
> I installed the 400Hz sub-rx filter some time ago. It works OK. Only the
> main receiver
> 500Hz is deaf, which makes me think of some bad contact.
>
> Is this 500Hz main filter a plug-in type, or is it soldered?
>
> Thanks
>
> Marcelo, PY1KN
>
>> Classification: UNCLASSIFIED
>> Caveats: NONE
>>
>> The D didn't come with a narrow filter for the Sub-Receiver, and I
>> believe that it's the only filter that was left out of the D. Because
>> the Sub-Receiver narrow filter position isn't jumpered when the filter
>> isn't installed, it is normal for the Sub-Receiver to go "dead" when you
>> try to use its missing narrow filter. Are you sure that the filter was
>> installed initially? It might have always been this way, and you just
>> didn't notice until now.
>>
>> 73, N5SK
>>
>> -----Original Message-----
>> From: yaesu-bounces@contesting.com
>> [mailto:yaesu-bounces@contesting.com]On Behalf Of Cecil Acuff
>> Sent: Monday, June 26, 2006 9:54 AM
>> To: marcelo@alternex.com.br; yaesu@contesting.com
>> Subject: Re: [Yaesu] FT1000D Filter Location
>>
>> I have not experienced your problem...but the filters are located on the
>>
>> bottom side of the radio. That is assuming you are talking about the
>> 500hz
>> filter for the main receiver. The sub receiver filter is on the right
>> hand
>> side of the radio.
>>
>> You will need to remove the top cover...flip the radio over on a nice
>> flat
>> surface with a towel or something under the radio to protect it and the
>> surface you are working on. Then remove the bottom cover and the
>> filters
>> will be obvious at that point.
>>
>> Good Luck...
>>
>> Cecil...
>> ----- Original Message -----
>> From: <marcelo@alternex.com.br>
>> To: <yaesu@contesting.com>
>> Sent: Monday, June 26, 2006 8:18 AM
>> Subject: [Yaesu] FT1000D Filter Location
>>>
>>> Hello
>>>
>>> After moving the rig form a stored location to the shack, my FT1000D
>>> became deaf when
>>> using the 500Hz CW filter. All other mode/filters are ok.
>>>
>>> I have little experience in repairing, but usually this is a bad
>>> connection at the
>>> filter, due to vibrations when transporting the rig. So I want to
>> check
>>> these
>>> connections first.
>>>
>>> Where is this filter located inside the FT1000? Has anyone experienced
>> a
>>> similar situation?
>>>
>>> Thanks
>>>
>>> Marcelo, PY1KN
>>>
>> Classification: UNCLASSIFIED
>> Caveats: NONE
>>
>>
>
>
> _______________________________________________
> Yaesu mailing list
> Yaesu@contesting.com
> http://lists.contesting.com/mailman/listinfo/yaesu
>
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|