Hello,
Thanks for the help.
I installed the 400Hz sub-rx filter some time ago. It works OK. Only the main
receiver
500Hz is deaf, which makes me think of some bad contact.
Is this 500Hz main filter a plug-in type, or is it soldered?
Thanks
Marcelo, PY1KN
> Classification: UNCLASSIFIED
> Caveats: NONE
>
> The D didn't come with a narrow filter for the Sub-Receiver, and I
> believe that it's the only filter that was left out of the D. Because
> the Sub-Receiver narrow filter position isn't jumpered when the filter
> isn't installed, it is normal for the Sub-Receiver to go "dead" when you
> try to use its missing narrow filter. Are you sure that the filter was
> installed initially? It might have always been this way, and you just
> didn't notice until now.
>
> 73, N5SK
>
> -----Original Message-----
> From: yaesu-bounces@contesting.com
> [mailto:yaesu-bounces@contesting.com]On Behalf Of Cecil Acuff
> Sent: Monday, June 26, 2006 9:54 AM
> To: marcelo@alternex.com.br; yaesu@contesting.com
> Subject: Re: [Yaesu] FT1000D Filter Location
>
> I have not experienced your problem...but the filters are located on the
>
> bottom side of the radio. That is assuming you are talking about the
> 500hz
> filter for the main receiver. The sub receiver filter is on the right
> hand
> side of the radio.
>
> You will need to remove the top cover...flip the radio over on a nice
> flat
> surface with a towel or something under the radio to protect it and the
> surface you are working on. Then remove the bottom cover and the
> filters
> will be obvious at that point.
>
> Good Luck...
>
> Cecil...
> ----- Original Message -----
> From: <marcelo@alternex.com.br>
> To: <yaesu@contesting.com>
> Sent: Monday, June 26, 2006 8:18 AM
> Subject: [Yaesu] FT1000D Filter Location
>>
>> Hello
>>
>> After moving the rig form a stored location to the shack, my FT1000D
>> became deaf when
>> using the 500Hz CW filter. All other mode/filters are ok.
>>
>> I have little experience in repairing, but usually this is a bad
>> connection at the
>> filter, due to vibrations when transporting the rig. So I want to
> check
>> these
>> connections first.
>>
>> Where is this filter located inside the FT1000? Has anyone experienced
> a
>> similar situation?
>>
>> Thanks
>>
>> Marcelo, PY1KN
>>
> Classification: UNCLASSIFIED
> Caveats: NONE
>
>
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|