Hello
After moving the rig form a stored location to the shack, my FT1000D became
deaf when
using the 500Hz CW filter. All other mode/filters are ok.
I have little experience in repairing, but usually this is a bad connection at
the
filter, due to vibrations when transporting the rig. So I want to check these
connections first.
Where is this filter located inside the FT1000? Has anyone experienced a
similar situation?
Thanks
Marcelo, PY1KN
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|