Re: [Yaesu] Band Data question

[Jerry Flanders <jeflanders@comcast.net>]

I don't have a direct answer, but the information and photos concerning the 
cables required for the Quadra interface at:

http://www.qsl.net/ab4oj/quadra/w4uk.html

might help.

Jerry W4UK

At 17:40 3/20/04, Don Richards wrote:
> In the past, some errors have been found in the Yaesu manuals and I would
> like to know if my FT-1000MP Mark V manual is correct when it shows the Band
> Data connections (page 4) as follows:
> Pin 1= +13 vdc
> Pin 2= Tx gnd
> Pin 3= Gnd
> Pin 4= Band A
> Pin 5= Band B
> Pin 6= Band C
> Pin 7= Band D
> Pin 8= Linear
> Also is the drawing on page 4 correct when it shows the pinouts as one would
> see them when looking at the rear panel of the transceiver?
>
> I would appreciate a reply direct to donsay2@cox.net


_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu