In the past, some errors have been found in the Yaesu manuals and I would
like to know if my FT-1000MP Mark V manual is correct when it shows the Band
Data connections (page 4) as follows:
Pin 1= +13 vdc
Pin 2= Tx gnd
Pin 3= Gnd
Pin 4= Band A
Pin 5= Band B
Pin 6= Band C
Pin 7= Band D
Pin 8= Linear
Also is the drawing on page 4 correct when it shows the pinouts as one would
see them when looking at the rear panel of the transceiver?
I would appreciate a reply direct to donsay2@cox.net
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|