[Yaesu] FT 101F

["Anibal Dos Ramos" <yy5arr@hotmail.com>]

Hi All
I Just Bought a 101F. It is working fin on 40-80 and 160m and but it is not 
happening in 10-15 and 20 m :-/
The Behaviour of the metter during tune-up procedure for 10,15,20m band is 
not the same than the working bands(40,80,160, the metter behaviour is quite 
linear and soft, it is not happening in the non working bands), even so, if 
I tune it up (after figting with preselect, plate...) as far as I try to 
start listening, then i can see that the preselect is not located in the 
maximun noise position, but if i move it in order to hear, then i will lose 
the power in the TX...

Is any FT101F owner has experince this kind of situation?

Heeelp!!!

Anibal
yy5arr

_________________________________________________________________
Consigue aquí las mejores y mas recientes ofertas de trabajo en América 
Latina y USA: http://latam.msn.com/empleos/

_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu