In a message dated 1/10/00 9:06:45 AM Eastern Standard Time, a_borg@yahoo.com
writes:
<<
To All 920 er's,
Does anyone know the correct driver pot to increase
the output drive to the final amps ? I'm mainly
interested in increasing the average mic drive output.
Mike KK4MS >>
On CW mode, I increased the output to about 110w. Mine was less than 95w out
of the box. HOWEVER, I was still dissapointed to find that the average voice
output was still way down as compared to other HF rigs I own. It will peak at
100w or so on a whistle or steady tone, but on voice it averages around 25w
or so.
Radio cops note:
I am quite aware of the difference between RMS and PEP readings, but it is
well known that some of the newer radios are not delivering as strong of an
SSB output as compared to, let's say, a Kenwood TS450S.
73 Eric
KK2ED
--
FAQ on WWW: http://www.qsl.net/k7on/yaesu.html
Submissions: yaesu@contesting.com
Administrative requests: yaesu-REQUEST@contesting.com
Problems: owner-yaesu@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|