Check sub-band mapping. I am afraid I don't recall how to edit it, but have
seen it happen before. The CW sub-bands should be set full bandwidth of
course Which is the green line on the bandmap on my display.
On Sun, May 3, 2020 at 4:10 PM Robert Hess via WriteLog <
writelog@contesting.com> wrote:
> Same here. 12.49E
> BobW1RH
> On Sunday, May 3, 2020, 08:11:15 AM PDT, Ron Dohmen <ron@n0at.net>
> wrote:
>
> I've been running some of the QSO parties this weekend. I have the packet
> window open and the bandmap window open. I can click on a call in the
> bandmap to set my rig to that frequency and enter the callsign into the
> call
> field. If the frequency is below 50 KHz in the band (<14050) then it works
> as expected. If the frequency is above 50 KHz in the band (>14050) then
> the rig mode changes mode to RTTY. How do I keep the rig in CW mode when
> clicking on a bandmap call high in the band?
>
>
>
> 73 de Ron N0AT
>
>
>
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
--
Jim K0XU
jim@rhodesend.net
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|