Hi Paul,
Thanks for the reply. I tried the Echo Microphone option as well as the other
Sound Board settings, to no avail.
I don't want (or need) to run the microphone thru the PC for processing. The
latency also messes me up, since I use the monitor function of my TS850S. I use
an outboard box (Symetrix 528E) to flatten the dynamic range. With some EQ and
the TS850's built-in speech processor, my TX audio has A LOT of punch.
Tech support at West Mountain says the RB Pro shouldn't be using the "Process"
function when sending computer audio, and microphone audio should work thru the
box w/o being in the "Process" mode. It's bassackwards but, worked at one
time. Perhaps I should post this to a RB reflector.
Bryan WA7PRC
________________________________
>
>
>From:Paul VA3PC <va3pc@ciinet.org>
>To:Bryan Swadener <bswadener@yahoo.com>
>Sent:Thursday, June 26, 2014 5:32 PM
>Subject:Re: [WriteLog] WL DVK w/ Rigblaster Pro
>
>Bryan; I have that setup except for the WinKeyer. Do you have the echo
>microphone box checked in writelog?
>If I remember correctly, that was the only way I could get it to
>transmit voice in the process position.
>(It goes thru the soundcard in the computer (slight delay/echo), but
>others don't notice it on the air.)
>I am not at home yet, but will check it out tomorrow when I get home.
>73
>Paul, VA3PC
>
>
>On 26/06/14 18:12, Bryan Swadener via WriteLog wrote:
>> Hi WL List Members,
>>
>> I've been going batty in trying to make WL (v10.78) work with my Rigblaster
>> Pro on SSB. At one time, it worked. However, a lot of time has passed and I
>> have added a WinKeyer USB to get rid of the corrupted Morse problem w/
>> WinXP. On CW, it now works fine but on fone, not so good.
>>
>> The Rigblaster box has a "Process" toggle switch that passes computer audio
>> to the rig only when it's in the "Process" position but does not pass
>> microphone audio to the rig in that position. And, when the switch is in
>> the "Process" position, it does NOT pass microphone audio to the rig.
>> Microphone audio is passed to the rig only when the switch is not in the
>> "Process" position. PTT works but, the only time the Rigblaster "PTT" LED
>> comes ON is when connecting to the PC when the PC sees it. I spoke with West
>> Mountain Radio support. We believe there's a problem with communication
>> between WL and the Rigblaster box, possibly a configuration issue in WL.
>>
>> The Rigblaster wants to be COM6, and the WinKeyer wants COM7. I've edited
>> CommSlot1 and CommSlot2 in the [PORTS] area of WRITELOG.INI to have those
>> values. Is there something more I need to do or change? I'm not trying to do
>> anything more... no rig or rotator control, etc.
>>
>> vy 73,
>
>> Bryan WA7PRC
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|