I use DXpedition mode all the time from P40A and it works fine, with one
exception. Sometimes I hit the space bar and it goes into the name field.
It is a real pain, especially with a laptop, to get it back to the
callsign if I need to make a correction. Is there a way to eliminate this
field?
John KK9A
To: "WriteLog Reflector" <writelog@contesting.com>
Subject: Re: [WriteLog] How to setup Writelog for W1AW
From: "Gary AL9A" <al9a@mtaonline.net>
Date: Wed, 28 May 2014 18:05:05 -0800
List-post: <writelog@contesting.com">mailto:writelog@contesting.com>
Steve,
Yup, that's what's happening! I can enter the same call on the same band
and as long as the mode is different, no dupe! Just a bit confusing. You
would think that would be an easy bug to fix. Thanks for letting me get a
good nights sleep tonight!
73,
Gary AL9A
-----Original Message----- From: Gary AL9A
Sent: May 28, 2014 5:32 PM
To: WriteLog Reflector
Subject: Re: [WriteLog] How to setup Writelog for W1AW
Steve,
Well, that's certainly interesting! I will try to set it up again tonight
and make a few "dummy" entries into the log and see how it dupes. If it
accepts the same call on the same band but with a different mode and doesn't
flag it as a dupe then it must be the DXpedition module even though it says
DXCC tracking module. Thanks for the tip.
73,
Gary AL9A
-----Original Message----- From: Steve AI9T
Sent: May 28, 2014 5:06 PM
To: Gary AL9A ; WriteLog Reflector
Subject: Re: [WriteLog] How to setup Writelog for W1AW
Gary
I always pick DXpedition mode and down at the bottom is always shows
General DX Tracking.
--
73
Steve AI9T
http://www.ai9t.com
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|