WriteLog
[Top] [All Lists]

Re: [WriteLog] WriteLog 11.11 Released!

To: Jim McDonald <jim@n7us.net>
Subject: Re: [WriteLog] WriteLog 11.11 Released!
From: Steve AI9T <steve@ai9t.com>
Reply-to: steve@ai9t.com
Date: Thu, 18 Apr 2013 14:50:39 -0400
List-post: <writelog@contesting.com">mailto:writelog@contesting.com>
Jim

I'm using the MKII here as well. I have used 2 different configurations.

You can configure your Rttyrite window with the MMTTY.XMMT with Hardware FSK . Then in the MMTTY TX tab select your port. You will also need to check limiting speed under the USB button on the MMTTY MISC. tab. Do not check strict bps in you router with this configuration.

You can also configure the original MMTTY plugin with your Main Rttyrite window then configure your clone to use XMMT.ocx with 2Tone. This is _MY_ preferred method.

--
73

Steve AI9T

http://www.ai9t.com

AI9T DX Cluster

Version 4 AI9T   Telnet: dxc.ai9t.com port 7300
Version 6 AI9T-2 Telnet: dxc.ai9t.com port 7373 (CW + Skimmer)



On 4/18/2013 2:25 PM, Jim McDonald wrote:
I am using XMMT.ocx for 2Tone and MMTTY.  I have 2Tone in the main Rttyrite
window with cloned receive windows for MMTTY and my DXP38.

With my microKEYER II, I am getting what seems to be slow, choppy
transmissions with "strict bps" checked in microHAM Router.  Without that
checked, then the messages get truncated after a couple of seconds.

Did I forget a setting?  Would this problem be eliminated if I were just
using the transistor/resistor FSK interface?

73, Jim N7US


-----Original Message-----


I can verify that the issue that had been reported regarding AFC action with
MMTTY using XMMT.ocx in the primary Rttyrite window has been corrected with
Version 11.11c. I also verified that the new Checkbox under XMMT setup for
AFC action can be used to make the state of AFC change with data in the Call
field, if the operator desires that.

The lockup condition with MMTTY using the Plugin for the primary Rttyrite
window has also been corrected.

I can now operate with MMTTY and 2Tone using XMMT.ocx without the need for
the MMTTY Plugin.

Thanks Steve and Wayne!

73, Bob WB2COY



_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/


_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/

<Prev in Thread] Current Thread [Next in Thread>