Dave, Don
When I get into that split situation I usually tune VFO A to the receive
stn, set the split freq, then "hold" the REV button. When the SteppIR
controller tunes to the VFO B freq, then I go to Manual tune. I'd rather
have the ant a bit off on SWR for the receive signal, but near to right on
for Xmit. I have the SteppIR DB-18 with the K3/100 and KPA500. Don't think
WriteLog can do anything. I also show both receive and transmit freqs in the
WriteLog log window.
73, Rick, W7LKG
-----Original Message-----
From: WriteLog [mailto:writelog-bounces@contesting.com] On Behalf Of Don
AA5AU
Sent: Wednesday, March 06, 2013 06:33
To: WriteLog
Subject: Re: [WriteLog] WriteLog and SteppIR
Dave, I also put my SteppIR in manual mode with operating split when the
split in frequency causes the antenna to tune.
I don't think there's anything you can do about it.
73, Don AA5AU
>________________________________
> From: David Strout <djsatty@comcast.net>
>To: WriteLog <WriteLog@contesting.com>
>Cc: WA2TML <colabrese@comcast.net>
>Sent: Wednesday, March 6, 2013 7:15 AM
>Subject: [WriteLog] WriteLog and SteppIR
>
>Setup: WinXP; WriteLog, SteppIR Monstr
>Is there some way to get WriteLog to use the split freq (VFO B) for
>transmit when split is set? At present, in contests on 40M, I have to
>set the SteppIR control to manual to select the freq when in split and
>the xmit stn is received on VFO A. Tnx Dave, W2YC
>
>_______________________________________________
>WriteLog mailing list
>WriteLog@contesting.com
>http://lists.contesting.com/mailman/listinfo/writelog
>WriteLog on the web: http://www.writelog.com/
>
>
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|