What is the connection between your serial port and the rig?
Per the WirteLog Manual (help file), CW output is on DTR (pin 4)
and PTT (if enabled) output is on RTS (pin 7).
The symptoms would indicate you have connected PTT (RTS/pin 7)
to the key line (tip of the Key jack) instead of CW (DTR/pin 4).
73,
... Joe, W4TV
On 10/15/2012 6:38 PM, Anthony (N2KI) wrote:
Hello Folks,
I need some setup help with WriteLog keying from a comport.
Here is what I have so far.
PORT SET UP SCREEN
Com6 is selected and the CW bullet is enabled,
Rig Type in NO RIG
Baud Rate is DEFAULT
Poll is ticked
Com PTT is YES
CW Kyer Type is PC GENERATES
All mode PTT on RTS is ticked
CW PTT SCREEN
Command rig on COM port is enabled.
With these settings for an FTDX5000MP, with the keyer on the radio enabled,
the radio transmits and I get a bunch of DITS.
With the Keyer disabled the radio transmits and I get one long DAH.
Of course BK-IN is enabled for both scenarios.
The com port works fine in MixW but not in WriteLog. Can someone
suggest where else to look? Did something change in version 11.07D?
Thank you.
Regards,
Anthony J. Cioffi (N2KI)
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|