Hi Kip,
Thanks for the info. No wonder I could not find it. In the Ohio Qso
Party module, "Setup Bands" is greyed out.
Here is the problem I had with the log. I made some Qsos on 80m ssb at
3650 khz. The log treated these as "out of band" and gave me a RED B next to
the sequence number. The only way I could get around the problem, was to
change the frequency to 3755 khz in the log entry so it would count the Qso
as being "in band".
After exporting the Cabrillo file, then I edited the frequency back to 3650
in the Cab file before sending it to the contest sponsor.
I could not find any other way to get WriteLog to count the Qso as being
in band.
The other problem I had with this OQP module, was that it would not take a
received serial number greater than 3 digits. That too, I had to edit in
the Cab file.
73, Geo...
George Wagner, K5KG
941-400-1960 cell
In a message dated 8/28/2011 12:50:45 P.M. Eastern Daylight Time,
kedwards@ltol.com writes:
George,
"Bands" (6th over from the left), then "Setup Bands."
73, Kip W6SZN
-----Original Message-----
From: writelog-bounces@contesting.com
[mailto:writelog-bounces@contesting.com] On Behalf Of Georgek5kg@aol.com
Sent: Sunday, August 28, 2011 9:38 AM
To: writelog@CONTESTING.COM; support@writelog.com
Subject: [WriteLog] Band Setup menu
WriteLog documentation describes a Band Setup menu. However, I cannot
find Band Setup in the application. Where is it?
George Wagner, K5KG
941-400-1960 cell
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|