Good point Jim.
The only different that I did was use 4800b instead of 38400
Here's the post:
Hi Bob:
Here are my settings which work just fine. If you have a SteppIR antenna
which also requires comms to the K3, you will need a Y cable from SteppIR in
order to link the K3 to both your PC and the SteppIR.
In WriteLog
Port Setup
I use COM 1
I have CW checked
Rig type = K2
Baud rate = 38400
I have Poll checked
Comm PTT = No
Further down, I have All mode PTT on CW port checked
>From Port Setup, press the CW PTT button CW PTT SETUP I have None (e.g. QSK)
checked
On the K3
Config:PTT-KEY = RTS-DTR
These are just my settings which work perfectly. I have to turn on the K3
VOX or QSK. Other settings might also work just fine.
I can send you screen snapshots if any of the above is unclear.
Good luck & 73
Mike K2MK
-----Original Message-----
From: jjreisert@gmail.com [mailto:jjreisert@gmail.com] On Behalf Of Jim
Reisert AD1C
Sent: Saturday, May 01, 2010 9:44 PM
To: Bob Garceau
Subject: Re: [WriteLog] writelog and K3
So what was the solution? I didn't see any posted to the reflector
(except a baud rates suggestion by W0YK). That way if someone else
has the same problem, and you post the answer to the reflector,
searching the reflector archives may turn up a solution for that
person.
73 - Jim AD1C
On Sat, May 1, 2010 at 1:29 PM, Bob Garceau <rgarceau@snet.net> wrote:
> Got it working. Thanks to the guys who responded.
>
>
>
> Bob, W1EQ
--
Jim Reisert AD1C, <jjreisert@alum.mit.edu>, http://www.ad1c.us
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|