----- Original Message -----
From: "Garry Shapiro" <garry@ni6t.com>
To: "Writelog reflector" <writelog@contesting.com>
Sent: Monday, May 21, 2007 9:08 AM
Subject: [WriteLog] Starting over again as a fetus
> The second parallel port,
> LPT3, drives a legacy HP LJ4M printer under either
> utility, but the LPT
> choices in the WL Setup window remain gray and
> unavailable. I have
> entered the standard IO ranges in both utilities (3bc-3bf,
> 278-27f.378-37f) and in DirectIO I have added IRQ 5 & 7,
> and a path to
> Writelog. No joy. No, I do not run both utilities
> simultaneously.
>
> The only difference I can note between the two computer
> setups is that
> this one uses XP Pro. So the question arises--does XP Pro
> unconditionally preclude access to the parallel ports, or
> is something
> else going on here? If the latter, what might it be?
My XP Pro works with DirectIO, but not Userport.
Suggestions:
Check the LPT resource assignments: control panel / system /
hardware / device manager / ports / LPT / printer /
resources. What happened to LPT 1?
Try addressing only one LPT port at a time.
Use K2QMF's Directio procedure, if you're not already:
1 - Open the Direct I/O control panel.
2 - In the I/O Ports Tab enter the BEGIN and END address.
For LPT1 it is 378 and 37A.
3 - Click ADD button ( This is the step they left out)..
4 - Go to the SECURITY Tab
5 - Click BROWSE button and locate writelog directory.
6 - From there locate writelog\Programs\WriteL32.exe and
click OPEN
7 - Click ADD.
8 - Close Control Panel...
Good Luck!
Dave Hachadorian, K6LL
Yuma, AZ
.
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|