I just installed a parallel port keying interface. When I open the
CW-RTTYWrite window, my rig goes into transmit and stays there. The
keying works fine, but the rig is locked in xmt. It stays in
transmit even with the alt-k window set for "receive."
I have the M8 RigBlaster interfaced to my 756 Pro. I just discovered
the problem will go away if unplug the mic. from the rig, disabling
the PTT. Then the rig will do break-in keying. But I'd rather use
the PTT built into the RigBlaster to control the transmitter.
I've been using this system for some RTTY contests, so the PTT works
properly in that mode.
Any tips appreciated.
TNX es 73, Mark WA9IVH
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|