miles wrote:
> At any baud rate, the serial link between writelog and the Ft9000
> drops "No Radio" shows up on the display.
> I have tried all baud rates from 4800 - 9600.
The cable is a stock 9 pin serial.
The link only stays up for a short time then drops.
----------------
Well, I've seen 3 causes for this using my OMNI VIB+.
1. The computer in use is too fast.
2. The computer in use is too slow.
3. In both cases, assuming the serial port is OK, it simply was a
matter of the computer ( or radio ) interrogating each other too
often. Results are "head on collisions" for lack of a better
description.
I've found that dropping to a much lower baud rate solves the
problem for me. Think I have the OMNI set at either 1200 or 2400.
Hope this helps.
73
Ed
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|