Here are some issues that I have.
Has anyone else seen similar.
Thanks,
Miles
Serial drop
At any baud rate, the serial link between writelog and the Ft9000 drops "No
Radio" shows up on the display.
I have tried all baud rates from 4800 - 9600.
The cable is a stock 9 pin serial.
The link only stays up for a short time then drops.
Split light.
Frequency when changing frequency by clicking on Spots or the Freq GUI bars,
the Split light on the 9000 keeps coming on.
I keep manually shutting off split, but it keeps coming back on.
Freq Gui bars.
When I click on a vfo gui bar, it will load the freq into the Primary
display.
Is there any way to use these as just a way toggle between the two a/b
vfo's.
If VFO A is the primary and I click on the gui for vfo B, it will load VFO A
with the values from the gui B.
I end up with both vfo A and B the same freq. What I would prefer is to
click on Gui A to become the primary or click B to become the primary, not
rewrite the primary, just toggle between the two.
Any input will be helpful full
Thanks, Miles
om/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|