Thursday, 11:30am
the saga continues...
OK, still not working, but....
Got old WL10.50 running on the other PC with Windows 98.
Connected IC751a CI-V line up to the COMM1 port and was able to read the radio
freq/mode as before.
Made sure that the W98 port was properly set up. (System Properties, Device
Managers, Ports, COM1 was set for 9600-baud, 8-bits, No parity, 1 stop bit and
Flow Control (I tried all 3 settings; None, Hardware and Xon-Xoff).
STILL NOT ABLE TO COMMAND THE RADIO FROM WL TO ANY FREQ/MODE.
So that pretty much says that I have a problem with this Piexx interface to WL
(even though other s/w loggers work OK).
Do you agree?
I have to take the covers off the IC751a to change baud rate on the UX-14
interface t0 4800-baud (from 9600-baud) and try again.
Oh... bye the way, is anyone else out there running WL thru a Piexx UX-14 to a
ICOM 751a? Does it work OK for you? What are you Piexx switch settings?
Jerry/k6iii
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|