On Oct 3, 2005, at 9:58 PM, ve2lx wrote:
> In other words we can not operate RTTY and CW while leaving both CW
> and RTTY cables on the rigblaster and on the good radio connectors
> for those modes and leaving the CW and the RTTY on the rigblaster
> board at the same time...we must remove the CW or the RTTY.
>
I ran into this exact problem when setting up to operate both CW and
RTTY with my FT1000MP and the RigBlaster Plus. Here's an excerpt of
my solution that I posted on a couple of lists (including this one, I
believe, a year and a half or so ago):
"Having gotten this far, I decided that the way to solve the problem
was to put in an additional switch for the DTR on Key jumper. I
drilled a small hole in the side of the RigBlaster Plus cover and
installed a small SPST toggle switch. I ran wires from this switch to
the DTR on Key jumper terminals on P5. When I want to do CW, I throw
the switch to close the jumper on DTR on Key. When I want to do FSK,
I switch it the other way, removing the jumper on DTR on Key. TXD on
Key is jumpered all the time."
Hope this helps.
73,
John E Bastin, K8AJS
jbastin@sssnet.com
http://www.qsl.net/k8ajs/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|