Jim
Look in the Help file under ini. then go to the [port] section, and you
will see a section that allows you to set a port to any com port. I have
used this to assign a port "slot" to com 7 and 8.
Byron, W3WKR
----- Original Message -----
From: "Jim Denneny" <denneny@comcast.net>
To: <writelog@contesting.com>
Sent: Tuesday, July 19, 2005 4:55 PM
Subject: [WriteLog] Serial Ports
> I recently acquired a second radio. I would like to assign the rig control
> to com 8. As I see it, Writelog only supports com 1 thru 4 for rig
control.
> Is there a way to assign rig control to a serial port other than those
> four? I am using com1 for my CI-V interface which controls my IC-910H.
My
> new radio is a Ten-tec Orion which does not interface the PC through the
> CI-V. Yes, I realize I can use an A/B switch on com1.
>
> Jim K7EG
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|