I recently acquired a second radio. I would like to assign the rig control
to com 8. As I see it, Writelog only supports com 1 thru 4 for rig control.
Is there a way to assign rig control to a serial port other than those
four? I am using com1 for my CI-V interface which controls my IC-910H. My
new radio is a Ten-tec Orion which does not interface the PC through the
CI-V. Yes, I realize I can use an A/B switch on com1.
Jim K7EG
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|