Well how in the world do I get the correct
port address?? And what do I do with it when
I get it????????????????
H E L P........... K2QMF
On Thu, 03 Feb 2005 16:26:22 +0000 Jerry Flanders
<jeflanders@comcast.net> writes:
> It went without any hitches for me a week ago also. Userport was
> easily
> installed and configured per the instructions. Note that a specific
>
> configuration for the exact port address on the PC is required. The
> default
> addresses shown as it starts up were NOT correct for my port.
>
> Good luck.
>
> Jerry W4UK
>
> At 15:23 2/3/2005, jduerbusch@charter.net wrote:
> >After reading there comments on the cw keying I decided to try it
> last
> >night. I had recently upgraded to Win/XP from Win98SE and I had
> been
> >keying cw with WL on a comport.
> >
> >Looking at the Port setup on WL all the LPT ports where grayed out.
> After
> >I ran the program Userport and re-booted I now have LPT1 and LPT3
> open and
> >both work fine CW keying my rig.
> >
> >One note, the Writelog.ini file address for LPT1 ~ 3 need to be the
> same
> >as what Windows has listed.
> >
> >So bottomline is that it works fine.
> >
> >But my other problem is that in DXBase2005 I can't get it to send
> CW from
> >the LPT port, go figure??
> >
> >Joe K0BX
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|