Rip,
First, I use the W5XD, so have no direct experience, BUT
when adding addresses to the .ini file, syntax is very important,
for example, mine says: LPT2=0x378 for LPT2,
0x378 is the syntax for the hex address 0378
So, give that a try, may be the answer,
if not, it's at least another piece of info
73
Ric KV1W
----- Original Message -----
From: "Rip Smith K3XO" <k3xo@dx.k3xo.net>
To: <writelog@contesting.com>
Sent: Saturday, January 29, 2005 16:02
Subject: [WriteLog] Parallel Port CW
> I have reached the end of my resources in trying to get Writelog to key
> my radio through the parallel port.
>
> I've had no problem getting parallel port keying to work with DXBase and
> the N3FJP software, and I am able to control the Icom 746 with Writelog
> and the other programs over the serial port.
>
> I downloaded the file dlportio.zip, and followed the procedure outlined
> for it.
>
> I extracted it and copied the files dlportio.sys and dlportio.dll to the
> \install folder, and then ran the install.exe program.
>
> All seemed to go OK and I rebooted.
>
> Then, I opened the writelog.ini file to edit it as described in the
> documentation. There was no LPTX= line so I added one and made it
> "LPTX=0378" which is the starting address for my printer port #1. I also
> added the line "CW_ON_PIN1=1" as described in the instructions.
>
> After all of that, when I go back into Writelog, I still do not have
> access to the printer port in the port setup screen.
>
> What have I missed?
>
> Rip K3XO
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|