WriteLog
[Top] [All Lists]

Re: [WriteLog] Re: Serial Numbers in Multi Operations

To: writelog@contesting.com
Subject: Re: [WriteLog] Re: Serial Numbers in Multi Operations
From: dl6jz@t-online.de
Date: Tue, 30 Nov 2004 08:46:56 +0100 (CET)
List-post: <mailto:writelog@contesting.com>
Hi Bob,

you are not fully right. Think of the WAEDC. In the MOST category there
are several transmitters TRANSMITTING at the SAME MOMENT allowed.
The 2nd, 3rd,.. transmitter are allowed to work mults only but there
can be more than one signal on the air at the same time.

So it would be fine if WriteLog is able to produce consecutive numbered
serials. But I know that this is a difficult problem.

73 + 55
Wolf, DL6JZ


Bob Naumann schrieb:
> Al,
> 
> You are not supposed to work two stations at once as a
> multi-single.
> 
> This is a rule violation.
> 
> There is no reason for WL to allow you to do this.
> 
> 73,
> Bob N5NJ
> 
> ============================================================
> From: Aldewey@aol.com
> Date: 2004/11/29 Mon PM 12:07:13 CST
> To: writelog@contesting.com
> Subject: [WriteLog] Re: Serial Numbers in Multi
> Operations
> 
> In a message dated 11/25/2004 10:31:04 PM Central
> Standard Time, Aldewey 
> writes:
> 
> > 
> > 
> > I know this has probably been discussed before but I
> just wanted to see if 
> > there is a simple answer.
> > 
> > In our Multi-Single SS Operation, we were running two
> networked stations.  
> > If we started to enter a Q in the entry window on
> Station #1, a Serial Number 
> > was automatically assigned.  If the op on Station #2
> starts to enter a Q at 
> > the same time, the same serial number is assigned. Once
> these numbers are 
> > assigned, there doesn't seem to be a way to change it. 
> If the Qs are both 
> > completed, they both go in the log with the same QSO
> Number.  Does anyone know a 
> > simple way around this dielemma?
> > 
> > TR seems to handle this a little better.  In the
> scenario described above, 
> > the same Serial Number is initially assigned (just like
> WL).  However, once 
> > someone enters the first Q, the serial number of the
> second radio is 
> > incremented automatically.  It does take some
> coordination between the two ops to make 
> > sure who has which number, but TR does make sure that
> duplicate serial 
> > numbers do not go into the log.
> > 
> > Any suggestions on how to accomplish this with WL?  
> > 
> > 73,
> > 
> > Al, K0AD
> > 
> > 
> 
> Before reverting back to TR for Multi-Op contests with
> Serial Numbers (i.e 
> SS, WPX, etc), I just wondered if anyone could point me
> to a solution to this 
> problem  when using Writelog.  I didn't get any response
> to my original post.
> 
> 73,
> 
> Al, K0AD
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web:  http://www.writelog.com/
> ============================================================
> 
> 
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web:  http://www.writelog.com/
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/

<Prev in Thread] Current Thread [Next in Thread>