WriteLog
[Top] [All Lists]

Re: [WriteLog] TS-480S Rig Control Woes

To: writelog@contesting.com
Subject: Re: [WriteLog] TS-480S Rig Control Woes
From: Eric Hilding <dx35@hilding.com>
Date: Thu, 11 Nov 2004 09:06:27 -0800
List-post: <mailto:writelog@contesting.com>
Tnx to all who responded.

For some bizarre reason, I had no COM ports showing under the [PORTS] section of the writelog.ini file (only two under the [RIGS] section).

So I manual edited the .ini file to add the following at the beginning of BOTH sections:

COM1:=4800,n,8,1,
COM2:=4800,n,8,1,
COM3:=4800,n,8,1,
COM4:=4800,n,8,1,

Special Tnx to Joe, K0BX for helping me resolve this.

However, if I change to another computer where COM1 thru COM4 are tied up with internal devices which may not be able to be changed, since the Writelog Setup | Ports options *only* include COM1 thru COM4, what would be the workaround? With more folks going to USB-Serial adaptors, can the Writelog COM options be expanded?

73...

Rick, K6VVA


_______________________________________________ WriteLog mailing list WriteLog@contesting.com http://lists.contesting.com/mailman/listinfo/writelog WriteLog on the web: http://www.writelog.com/

<Prev in Thread] Current Thread [Next in Thread>