To: | writelog@contesting.com |
---|---|
Subject: | [WriteLog] TS-480S Rig Control Woes |
From: | Eric Hilding <dx35@hilding.com> |
Date: | Wed, 10 Nov 2004 20:59:48 -0800 |
List-post: | <mailto:writelog@contesting.com> |
1. I installed a dual-USB serial port device COM3 & COM4) & connected a
serial cable to my TS-480S 2. I upgraded to WL 10.50D 3. I loaded WL and selected (Setup | Ports). Only "Kenwood" & "Kenwood TS-850" show as Kenwood options 4. I tried both Kenwood options 5. I tried 4800 baud and 9600 baud 6. I tried 1 stop bit and 2 stop bits 7. I tried various combinations of 4, 5 & 6 8. In each situation, I get "NO RIG" showing in the lower left hand corner of WL 9. If I click on "NO RIG" (which yields the Logging/Duping Frequency et.al. dialog box), and type in 14250, click the USB radio button, choose Log the frequency of qsos "rig on COMM3", click the SET button and then click the "OK" button, I hear a beep and the TS-480S goes to 14250. 10. The "NO RIG" control button in the lower left hand corner of WL still says "NO RIG" (and of course, the "R" inside the Green Circle is there (also in #8 above, actually). 11. Tuning the VFO dial on the TS-480S yields zip squat. 12. Frustration is a *mild* word for where I'm at. Any help is appreciated. Tnx & 73... Rick, K6VVA
|
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | [WriteLog] ssb messages, w3gt |
---|---|
Next by Date: | [WriteLog] RE: ssb messages, Eric Hilding |
Previous by Thread: | [WriteLog] ssb messages, w3gt |
Next by Thread: | RE: [WriteLog] TS-480S Rig Control Woes, Mike McCarthy, W1NR |
Indexes: | [Date] [Thread] [Top] [All Lists] |