At 13:39 -0700 08_24_2003, Steve Woodruff wrote:
As for the station setup info being saved across
logfile opens, that is behavior that my newer
modules have but some of my first modules do not
have that. If i had all the time in the world I
would update the older modules to write that info
to the logfile so it should be retrieved when the
log is opened.... but i haven't found the time
yet and it won't matter once BPL takes over. :)
BPL???
Remember, OHQP and my many other modules are not
supported by Ron or Wayne so asking for help about
them on this mailing list is not always going to
work.
I was under the impression, apparently an incorrect one, that saving
configuration info was something done in the program and not directly
controlled by the individual module, so I posted my comments on the
list.
Besides, you're lucky I saw this posting
with all of the posts about soundcards and virus
crap which has been flooding this list. If you
really need help with my modules, email me directly.
I will do that in the future. You're right, the signal-to-noise ratio
on the list can sometimes make finding useful information a challenge.
73,
--
_
/~\ The ASCII | J o h n B a s t i n K 8 A J S
\ / Ribbon Campaign | jbastin@sssnet.com K8AJS@arrl.net
X Against HTML | http://www.qsl.net/k8ajs
/ \ Email! |
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
|