The rules now for WPX allow for independent serial numbers per band/ station.
So you just go on SETUP // "Sort ordering and serial numbers" and check the
"Separate by band" option.
73?s
Marcelo
PY1KN
At 20:57 23/4/2003 -0500, you wrote:
>I am interested in an answer to this question, but have not seen a
>reply. Anyone know what is going on with this question?
>
>Lee - K0WA
>
>
>At 04:36 PM 4/22/2003 +0000, you wrote:
>>Hi Gang,
>>I have been putting together a small station comprising of a two radios
>>and two computers networked. All is OK with the network, however, how do
>>you stop both stations using the same QSO sequence number?.
>>
>>If say the Op on station 1 enters KP4xx the Sequence number appears to
>>the left of the KP4xx, but, if the Op on station 2 enters a callsign in
>>the call field before KP4xx is logged on station 1 then he gets the same
>>sequence number.
>>
>>With my daughter logging Qs in the next room at the same time as me, the
>>log looks real messy:
>>
>>Seq: 1, 2, 2, 3, 5, 6, 8, 8, 9, 10 ,10, 11, 13, etc...
>>
>>It works ok for an SO2R setup where I will only log one QSO at a time,
>>but what do you M/M or M/S op's do?
>>
>>I guess I am seriously doing something wrong.
>>
>>73 Darren G0TSM
>>
>>
>>
>>
>>
>>
>>
>>
>>
>>
>>
>>
>>
>>
>>
>>G0TSM Home page http://www.g0tsm.com
>>GB7EDX DX Cluster http://www.gb7edx.com
>>
>>
>>_______________________________________________
>>WriteLog mailing list
>>WriteLog@contesting.com
>>http://lists.contesting.com/mailman/listinfo/writelog
>
>
>_______________________________________________
>WriteLog mailing list
>WriteLog@contesting.com
>http://lists.contesting.com/mailman/listinfo/writelog
|