>From what I am reading it seems like YPLog does this and therefore it can be
done. I believe what you are trying to say is that if all rigs in the CT17
are on the same address then they all go to the same freq and WL is desinged
to talk to only one rig on one com port so you can't give it two CI-V
addresses.
I have asked for the support of this in the past and would use it if it were
available.
My suggestion for how to implement:
In INI file set two commslot's to the same com port
In Port Setup set two rigs to icom rigs of different types (if they are the
same rig then change the CI-V address on one of the rigs)
Implement logic in Writelog: if commslotX=commslotY and (rigX=Icom and
rigY=Icom) then open commslotX and do not open commslotY
73,
Zev N2WKS
-----Original Message-----
From: Dave N4IG [mailto:n4ig@tampabay.rr.com]
Sent: Monday, February 10, 2003 9:15 AM
To: writelog@contesting.com
Subject: Re: [WriteLog] ICOM
Hi all;
I was wondering about this and one related question.
Writelog hard codes the rig address and doesn't allow
the user to change it. At least I couldn't find a way
to do it. I have a new IC 746 pro and had to use the
IC 746 selection in Writelog. This required me to change the rig addressing
on the 746 PRO. No big deal for me since I don't do SO2R operating. The
whole point of using the IC
CT-17 is that you only need on Comm port for up to 4 radios. This can't be
done in Writelog because of the Hard coded rig address.
Or Did I miss something in the HELP file?
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
CONFIDENTIALITY NOTICE: This communication and any attachments are
confidential, and are only for the use of the intended recipient. If
you have received this transmission in error, any disclosure, copying,
distribution or the taking of any action in reliance upon this
communication is strictly prohibited. If you have received this
communication in error, please contact the sender immediately and
delete the original message. Thank you.
|