> -----Original Message-----
> From: writelog-bounces@contesting.com
> [mailto:writelog-bounces@contesting.com]On Behalf Of Kc9um@aol.com
> Sent: Sunday, February 02, 2003 03:39
> To: garry@ni6t.com; writelog@contesting.com
> Subject: Re: [WriteLog] SSB control question
>
>
> Ran into a similar problem with my Icom 756 Pro running through the
> Rigblaster Plus. Found the following notes on page 5 of the
> Rigblaster Plus
> owners manual:
>
> "In the AUTO mode your mic. is connected by default and it will
> work normally
> with your radio's vox. In the RIGblaster's VOX mode your mic is
> disconnected
> and your computer audio is hooked up. Therefore, your computer
> audio will be
> able to activate your rig's vox circuit."
>
> What the book doesn't explicitly say is that with RIGblaster VOX
> enabled your
> rig's mike is DOA unless you switch it back to AUTO! Seems kind
> of dumb to
> me.
>
> Gary KC9UM
>
Gary:
Yes, that is why the mic has to go to the soundcard mic input, even if there
is no need or intent modify the buffers, if one intends to use both the mic
and the buffers.
It one does not intend to modify buffer contents on the fly, the soundcard
output could go the Patch input on the radio, but the mic input is "live' in
that case.
Garry
Garry
|