Hi Jim --
WL will, in its current incarnation, do what you want while running. Go to
the Entry pull down menu and select "Enter sends
Exchange/QRZ". When this menu entry is checked (on), WL will do the following:
1. If the cursor is in the callsign field, and you type Enter, and the
callsign field is empty, WL will send you CQ message.
2. If the cursor is in the callsign field, and you type Enter, and the
callsign field has characters in it, WL will send the call
and your exchange message.
3. If the cursor is in one of the other fields in the QSO Entry form, and you
type Enter, WL will log the QSO and send your "TU
QRZ" message.
You can specify which of your F-key messages is your CQ, exchange, and TU
QRZ message. In the WriteLog.INI file, use the
following entries:
CqFunctionKey=11
QrzFunctionKey=3
SendCallExchangeKey=10
These entries go in the [Configuration] section of the INI file. Be sure to
remember to put "%C " at the beginning of the F-key
message you choose for SendCallExchangeKey; that is what gets the callsign sent.
You may also find this entry helpful:
MoveNextOnEnter=0
If '0', when you hit Enter while in the callsign field, the cursor stays in
the callsign field. (I do this because I'm usually
typing in the last couple of letters of the call after I hit Enter.) If you
specify MoveNextOnEnter=1, when you hit Enter, not only
is the call/exchange message sent... but also the cursor moves to the next
field in your QSO Entry form.
For S&P, WL does not use the Enter key (as far as I understand) for this
mode of operating. I've learned to simply poke the
F-key that transmits my call, and to use Shift-Enter to silently log the QSO
afterward.
Oh: this also works for SSB, in addition to CW and RTTY. And you never
need to use the mouse. Ctl-P will always take you to
the QSO Entry form. Space or Tab will move you from left to right from field
to field in that form. Shift-Space and Shift-Tab will
move you from field to field in the opposite direction.
Hope this helps.
73,
-- Eric K3NA
-----Original Message-----
From: writelog-admin@contesting.com
[mailto:writelog-admin@contesting.com]On Behalf Of Jim Smith
Sent: 2002 December 4 Wed 19:21
To: writelog@contesting.com
Subject: Re: [WriteLog] Operational Characteristics of WL on CW
[...snip...]
So, here's what I expect from a contesting program, such as WL, using CW
or RTTY.
Running
Someone answers my CQ
I, by whatever means, get his call into the call field (I forget the
WL terminology for this) and hit a key, preferably Enter.
WL sends his call and my exchange
I, by whatever means, get the caller's exchange into the exchange
field and hit a key, preferably Enter.
WL sends the QSL message AND LOGS THE Q.
S&P
I, by whatever means, get a call into the call field and hit a key,
preferably Enter
WL sends my call.
When the called station answers I, by whatever means, get his exchange
into the exchange field and hit a key, preferably Enter.
WL sends my exchange AND LOGS THE Q.
So, to complete and log a Q requires the
keystrokes/mouse-swipes-and-clicks to enter the call and the exchange
plus two Enters.
[...snip...]
73 de Jim Smith VE7FO
|