I don't think you can do rig control and FSK on the same port. They both
use TXD. FSK out might not confuse the rig, but rig control would go out as
FSK if PTT is active.
At 07:40 AM 8/24/02, you wrote:
>I -told- you I was only partially awake! *FSK* is on the TxD pin, so you
>can have it all!!
>
>----- Original Message -----
>From: "wa9als" <wa9als@starband.net>
>To: <k0bx@qsl.net>; <writelog@contesting.com>
>Sent: Saturday, August 24, 2002 7:14 AM
>Subject: Re: [WriteLog] RigControl & Soundcard PTT/FSK on same port?
>
>
> >
> > > I thought I had read that someone did this with a 'Y' cable??
> > >
> > > It looks like it almost can be done,
> > > 9 pin connector
> > >
> > > pins (2) TXD and (3) RXD for rigcontrol
> > >
> > > pin (7) RTS or (4) DTR for PTT
> > >
> > > But that leaves us without a pin for FSK??
> > >
> > > Any Ideas???
> > >
> > > Joe K0BX
> >
> > Hi Joe - I'm only partially awake so far, but I think the "Y" cable
>referred
> > to was as above, except with PTT on RTS and -CW- on DTR. What you need is
> > PTT VIA RIG CONTROL. Assuming your rig supports that, you should be all
> > set. 73
> >
> >
> >
> > _______________________________________________
> > WriteLog mailing list
> > WriteLog@contesting.com
> > http://lists.contesting.com/mailman/listinfo/writelog
> >
> >
>
>
>_______________________________________________
>WriteLog mailing list
>WriteLog@contesting.com
>http://lists.contesting.com/mailman/listinfo/writelog
Jim Rhodes K0XU
jim@rhodesend.net
|