Those addresses are set up by the program FPROT16.exe. If you rename it you
can edit the INI file and set the correct value.
Remember, the port addreses do not have any standard addresses. Even in the
old DOS world, LPT1 was the first default address that was found at boot
time.
----- Original Message -----
From: "Katsuyuki ISHII" <kkii@hcc1.bai.ne.jp>
To: "David H. Walker" <k0cop@earthlink.net>; <writelog@contesting.com>
Sent: Sunday, June 02, 2002 15:32
Subject: [WriteLog] Re: lpt
> Dear David:
>
> >Just make sure that Port 2 in WL has the same address has the port you
are
> >using in your computer. The port number is not important. The address is.
>
> Thank you very much for your comments.
>
> I guess that you told me to open writelog.ini and to check the address of
Port 2.
> So I did them and found the following.
>
> LPT1=0x3bc
> LPT2=0x378
> LPT3=0x278
>
> According to these informations, I set up DirectIO and run Writelog. But
the
> situation is not changed.
>
> The address of LPT1 is 0x378 in BIOS of my computer. I wonder if this
difference
> causes the problem...
>
> Any help and comments will be appreciated.
>
> Katsuyuki Ishii (JR4ISF & N8QDB)
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
>
>
|