Dear David:
>Just make sure that Port 2 in WL has the same address has the port you are
>using in your computer. The port number is not important. The address is.
Thank you very much for your comments.
I guess that you told me to open writelog.ini and to check the address of Port
2.
So I did them and found the following.
LPT1=0x3bc
LPT2=0x378
LPT3=0x278
According to these informations, I set up DirectIO and run Writelog. But the
situation is not changed.
The address of LPT1 is 0x378 in BIOS of my computer. I wonder if this
difference
causes the problem...
Any help and comments will be appreciated.
Katsuyuki Ishii (JR4ISF & N8QDB)
|