I don't know what you're using for a TNC, but since you're running FSK, it
could be that your TNC is not set to the correct frequency pair on receive
that match the transmit mark/space freqs. This is a LOT easier than trying to
play with the FSK offsets on the rig. Find someone using K6STI's software who
can tell you how far you're offset, make a first pass at changing them in the
software setup, and then recheck. This should get you rignt on freq.
73, Duane
KG8DH@aol.com wrote:
Alright folks, anyone have any idea where the mark frequency can be adjusted
on the 765. Don, AA5AU, suggested that I adjust it as my transmit frequency
and receive frequency vary about 100 hz in tone, and in operating this past
weekend, I had several contacts have to move to decode my signal. Not a good
thing! I looked through my owners manual, and I can't find one word about
adjusting the tone. If anyone has an idea where this is at, I would
appreciate it.
Thanks
Geary
KG8DH
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
Duane Calvin, AC5AA
Austin, Texas
____________________________________________________________________
Get free e-mail and a permanent address at http://www.amexmail.com/?A=1
|