Here's the reply I got from Direct IO. I sent the request this morning and
got a VERY quick response ... on Saturday! Needless to say, I just ordered
the permanent license of Direct IO for $29.00. The quick response on the
eval alone was worth that!
I think my mistake was setting the IRQ7. WL now drives my Top Ten DX
Doubler correctly. Woo-hoo!
I'll post a full and detailed explanation of the proper config later. Right
now, I want to do more wiring and try WL in the NAQP.
VY 73 de K3PP (Profoundly Pleased!)
----- Original Message -----
From: "Direct I/O Support" <support@direct-io.com>
To: "'Glenn O'Donnell, K3PP'" <k3pp@ptd.net>
Sent: Saturday, January 19, 2002 8:53 AM
Subject: RE: Problem report
> Dear Glenn,
>
> thanks for your interest in Direct I/O.
> 1) Please remove the IRQ7 from the config. WriteL32 doesn't use IRQs.
> 2) Please remove ports 278-27A and 3BC-3BE from the config. Only include
> _existent_ ports.
> 3) Re-enable the LPT standard driver. It is needed for the parallel port
> sharing.
> Hope this helps.
>
> Michael Paule
> -------------
> Ingenieurbuero Paule
> www.direct-io.com
> Paule@direct-io.com
>
> P.S: Have you heard about the Direct I/O Newsletter?
> Please visit http://www.direct-io.com/Direct-IO/whatsnew.asp#Newsletter.
>
>
>
>
>
> -----Original Message-----
> From: Glenn O'Donnell, K3PP [mailto:k3pp@ptd.net]
> Sent: Saturday, January 19, 2002 1:54 PM
> To: support@direct-io.com
> Subject: Problem report
>
>
>
> Direct I/O Problem Report
> =========================
> Report generated: 01/19/02 07:42:47
> Reporter version: 4.2.238
>
> [snip]
>
>
|