Hi Gil,
Try closing the Rttyrite window and use the CW Decoder instead found under
'Windows' on the Toolbar. It will decode your CW just fine and on multiple
channels and might take care of the noise you are hearing.
Also, open your native volume controls on your PC and mute everything except
'Volume.' Sometimes you will pick up noise using the sound card from the
'CD' channel or others because it's not muted.
CU...Scot, K9JY
K9JY's WriteLog User Support Site at:
http://www.k9jy.com
mailto:scot@k9jy.com
> -----Original Message-----
> From: writelog-admin@contesting.com
> [mailto:writelog-admin@contesting.com]On Behalf Of GilBaronW0MN
> Sent: Wednesday, December 12, 2001 02:54 PM
> To: Writelog@Contesting. Com
> Subject: [WriteLog] Noise in sound
>
>
> I was setting up for the 10 meter contest which is both CW and
> SSB and have
> discovered a problem that makes it very difficult to use sound.
> If the Rttyrite window is open then there is a T of noise in the
> output of a
> wave file that was previously recorded with no noise. If I shut
> the Rttyrite
> window then it is quiet. This means that I have to set up for CW if I want
> the CW decoding every tie I switch from SSB to CW and close and
> readjust the
> SSB windows when switching from CW to SSB.
>
> Has anyone noticed this problem and found a solution. I tried
> over and over
> with various configurations and cannot get rid of the noise.
>
> Gil Baron http://webpages.charter.net/gbaron
> 44:04.925 N 92:30.758 W 1055'
> "Hierro candente, batir de repente"
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
|