Think I might have found part of the problem. What it boils down to is
this:
(1) Using the dial or band switch and WL keeps up
(2) Use the rig's number pad to punch in a frequency and WL keeps up.
(3) Use the QMB (Quick Memory Bank) switch to jump back to previously saved
old frequency and there is disconnect between WL and the rig. WL is polling
the rig, (CAT indicator flashes) but never updates the screen.
So I presume that there is some sort of problem communications problem at
that point that keeps WL "blind" as to the rig's real freq. There is a work
around so I am not going to worry about it at this point.
Had an absolute blast on the 160M contest this weekend. Once I knew what
would trip the problem I could avoid and all was well.
73s and cheers.
-ricK7log.
-----Original Message-----
From: Sherman Banks (W4ATL) [mailto:w4atl@yahoo.com]
Sent: Saturday, December 08, 2001 2:12 PM
To: Rick.Commo@verizon.net
Subject: RE: [WriteLog] FT-920 polling problem
My FT-920 works well with WL No problems. Good luck.
.
.
< lines deleted>
.
|