Frank,
Not sure about the W1WEF I/O , but LPT CW with the simple one transistor
I/O shown in the Help file, using "Setup Ports" is a simple way that works
for me, with no need to edit the INI file manually for CW ops. In the left
hand column headed "CW" just click on the button for LPT1. Since you have
your rig control on Com 1, (check this also while you're in Setup Ports,)
go down to the CWPTT button and set it for "Command Rig on Com Port." Then
do Setup, Save Configuration when you're through. Also be sure you don't
have VOX enabled on the rig. (On my TS-850 I leave the VOX/MAN button set
to MAN. )
73 de Jon, K1US
----- Original Message -----
From: "Frank Grossman (WB2BXO)" <flgrossman@earthlink.net>
To: <writelog@contesting.com>
Sent: Sunday, July 15, 2001 5:44 AM
Subject: [WriteLog] ini setings for LPT keying
>
> I send CW with the W1WEF LPT keying cable when using CT, Writelog and
> DX4WIN, but I seem to have a hard time getting the keying function to
start
> in Writelog. (Works fine with DX4WIN and CT) I suspect the problem is a
> lack of experience with the program, but it occurred to me that there
might
> be a simple solution--set up LPT keying in the .ini file instead of going
to
> setup | ports, clicking the LPT1 button and "computer generated," each
time
> I start a CW log.
>
> I set up rig control on com-1 in the .ini file, but don't know what to do
> for keying on LPT1.
>
> Thanks and 73,
> Frank
> wb2bxo@arrl.net
>
>
>
>
> --
> WWW: http://www.writelog.com/
> Submissions: writelog@contesting.com
> Administrative requests: writelog-REQUEST@contesting.com
> Problems: owner-writelog@contesting.com
>
>
>
--
WWW: http://www.writelog.com/
Submissions: writelog@contesting.com
Administrative requests: writelog-REQUEST@contesting.com
Problems: owner-writelog@contesting.com
|