I want to follow up with this thread for any looking at it in the future.
From the advice given, two things stand out. First thing is that if at
all possible, meet up with someone who is already doing VHF contesting
and observe or participate in a contest. The second thing is to look at
the equipment you already have in comparison with the different
categories offered by the contest.
My journey so far has been determine where I can be the most competitive
in the shortest amount of time. So looking at the categories, I
immediately eliminated the multi-operator ones. This drops both limited
and unlimited multi-operator, and unlimited rover categories. I do not
currently have any amps, so I eliminated the single operator high power
category and the rover category. Next I eliminated the single operator
portable category because the Gulf Coast area where I live is relatively
flat and close to sea level, so unless I could gain access to the top of
one of Houston's skyscrapers, 10w just wouldn't be enough. Then I
eliminated single operator, low power and limited rover because to
operate at the max power allowed, would again require amps that I don't
currently have and would take a while to acquire.
This leaves single operator, 3 band (SO3B) and single operator, FM only
(SOFM). This is where I began to "deep dive" into the contest results
going back three years. I examined the top five results in each
category, looking at multipliers per band and qsos. I found that for
SO3B an upper limit of multipliers for 6m is between 100 and 200 in June
and the other bands having between 15 and 40. The other contests have a
fairly even spread of multipliers between 10 and 35 across all three
bands with a slight edge going to 2m. For the SOFM category, I found
that the order of importance of the bands is 2m with 15-100 multipliers,
then 70cm with 10-50, then 6m with under 10, and lastly 1.25m with under 5.
With the multiplier numbers, I then looked at the map to see the
distances covered to get the multipliers and if it would even be
reasonable to get that many from my location. The conclusion that I
came to is that the SO3B category would offer me the most chance to do
well. If I upgrade to a Kenwood TS-2000 or ICOM IC-9100, then I would
have maximum power without amps or for slightly less than the TS-2000, I
can add two amps to what I already have. That will have to be looked at
further.
Also I need to look at antennas, which is where the most "bang for the
buck" is to be found.
Michael Murphy
K5MBM
EM20
On 11/3/2016 12:00 PM, Michael Murphy wrote:
Thank you all who responded. You've all given me something to think
about.
Following on some of the advice given, I am going to shoot for FM only
in the January contest. I will not have moved to the new location yet
so it won't be optimum, but it will be a start. All I really need to
do is get a 6 meter FM antenna up. I already have a Comet CX-333 for
2, 1.25 and 70cm. I am thinking of getting a Dominator 6M antenna
from Norwalk Electronics. It will handle 1500 watts and is highly rated.
Right now my antennas are mounted on 20' poles attached to the eave of
the house. I have 10 segments of Rohn 25g to put up at the new
location, but I am thinking of a temporary 30' setup with the 6M
antenna attached to the top. Along with setting up the logging
software, I should be able to get it all done by the January contest.
As somebody said, this will give me experience in the process from
beginning to end and afterwards I can evaluate what needs to be improved.
Again Thanks,
Michael Murphy
K5MBM
EM20
On 10/29/2016 11:13 PM, Michael Murphy wrote:
This is an opinion question, so tell me your opinion and why you feel
the way you do. I have been wanting to get into vhf contests, but
haven't got it all together yet. I currently have a Yaesu 450D and
100D. Also have 3 Tyt 9000 (2m, 1.25m and 70cm FM). I will be
moving in a few months and have been thinking about the new shack and
thinking of upgrading the equipment. So if you were to start from
scratch to build a decent single operator station primarily for Vhf
contest (I've be doing HF just fine with what I've got now), what
equipment would you use? I like that the Elecraft K3 has support for
multiple transverters. I also like the Icom IC-9100 for its 2m and
70cm capability, but no transverter support. When it comes to
tranverters, I like the way the Elecraft transverters work with the
K3, but Demi has more band choices. As far as antennas go, I've only
got a triband vertical for the FMs. So any thoughts and comments are
welcome.
Sent from my iPad
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting
|