I had 2 of the "D" models that also did this as well as 3 of the pre "D"
models. I do
believe the "D" models I had (still have one) were the early models as well.
I also had a FT-897 that did this as well.
73
Gene
N0DQS
-----Original Message-----
From: Tad Danley
Sent: Thursday, February 12, 2015 6:19 AM
To: vhfcontesting@contesting.com
Subject: Re: [VHFcontesting] Yaesu FT100D problem on 6m
I think some early D models had this problem as well. I purchased my
FT-100D in 2000 and had the high SWR problem on 6 and 10. A warranty
trip to Yaesu fixed it with the additional grounding.
73,
Tad Danley, K3TD
On 2/12/2015 6:08 AM, Mike (KA5CVH) Urich wrote:
On Wed, Feb 11, 2015 at 8:54 PM, John Geiger <af5cc@fidmail.com> wrote:
I have not seen this problem in a FT100D before.
Mike asks
Are you sure its a "D"? This was a problem on the "pre-D" models, not
only on 6 but 10 & 12 as well. My "non-D" had to go back to Yaesu so
they could do the additional grounding that was necessary. They
repaired it and shipped it back to me at no cost. They also flashed
the firmware to the "D" firmware at the same time.
No problems since.
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting
|