Hi All,
I have for sale a DEM 1296-28 Transverter and 25W amp. The current
configuration of the DEM 1296-28 transverter is with a Common transverter IF
and split RF. 28 Mhz drive level is 1-250mW for up to 3W output. 28.1Mhz
=1296.1Mhz. Crystal heater mod added for EME stability. PTT to Ground (RCA
phono). I used it with an Icom 706MKIIG IF. I had an antenuator installed
inside the transverter so that power output on the 706 set at 2 gave a little
less than 1Watt out to drive the amp.
The 25W amp is a neat, well heat sinked Mitsubshi linear module (similiar to
the older DEM 30W amp) which will do 25W+ with a drive level just short of 1W.
PTT to ground (RCA phono). Nicely boxed with N hardware.
Comes with all cables and data sheet for the transverter. The only thing
you'll need to supply would be a coaxial relay for the split RF.
I purchased this equipment to use in my VHF rover but never got around to
installing it. Asking $425 + shipping.
73 Matt
W5LL
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting
|