Are these connectors similar to the two-piece BNC connectors with the
compression-fitting on the shield? I believe Amphenol calls those
Quicktrim (tm).
I have been using those extensively for a while and generally have good
luck with them through 432 MHz using high-quality RG-58 or LMR195.
However, I have never seen any info on exactly how to install them, so
it's been just a guess so far that worked out. However, I had a few I
got at a hamfest recently where the piece with the center pin didn't
fully seat into the BNC shell, and I had to do some extra manipulation
with the braid to make them work.
Does anyone have a data sheet on how they are supposed to be mounted on
the coax?
The standard N connectors were used on the old C-band TVRO LNA's at
3700-4200 MHz. I always hated putting them on in the field but they
worked just great.
73, Zack W9SZ
On Tue, 11 Apr 2006 w0eea@sbbco.net wrote:
>
> Hi Warren,
>
> Having both questions and reservations about these connectors, we made
> several cables with various typs of coax and checked them on a network
> analyzer. Our findings were that up to 2450 MHz they worked well, being
> indestinguishable from our sample cables with other types of N connectors.
> We were not pleased with the cables using the two piece N connectors at 3450
> Mhz and above for several reasons. These included non-repeatability of
> readings, impedence anomolies, and slightly higher attenuation for a given
> length cable when compared to properly made cables with Amphenol N
> connectors. The Amphenols are harder to install properly, but from 3 GHz
> up the reward the careful user.
>
> 73,
>
> Jim W0EEA
>
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting
|